Directions Sanitization: 1. Scrape and pre-wash utensils and glasses whenever possible. 2. Thoroughly wash equipment and utensils in hot detergent solution. 3. Rinse with potable water. 4. Add 60 ml (4 pumps) of this product to 30 L of potable water (or equivalent dilution). Test solution using a test strip and make sure that it’s at a concentration is at 200 ppm at the beginning of the cycle. If necessary, add additional pumps until a concentration of 200 ppm is reached. 5. Sanitize in the solution for at least 10 minutes making sure to immerse completely. 6. Remove items and place on a rack or drain board to air dry. Do not rinse. 1 L - Ready to use: Ready to use, no dilution required. To sanitize surfaces, clean surface with a good detergent and rinse with potable water. Spray the solution onto surface to thoroughly wet the surface. Allow the surface to remain thoroughly wet for at least 60 seconds. Remove excess liquid and allow to air dry on the treated surface. No rinising required. Formats Available: 1 L & 4 L │ Product Code: 57056, 57058